HP-GL/2 problems
Lines or images are missing in the HP-GL/2 data that was printed. ......................................................... 813
Lines Are Printed Too Thick or Thin During HP-GL/2 Printing .................................................................. 813
HP-GL/2 jobs are printed in monochrome (or color). ................................................................................ 813
Printed Colors in Line Drawings are Inaccurate During HP-GL/2 Printing ................................................ 813
HP-GL/2 jobs are printed 6 mm larger than specified ............................................................................... 814
HP-GL/2 jobs are printed at maximum size, even if a standard size is specified ...................................... 814
HP-GL/2 printing takes a long time. .......................................................................................................... 814
The printer stops when printing a HP-GL/2 job (the carriage stops moving) ............................................ 814
Lines or images are missing in the HP-GL/2 data that was printed.
Cause Corrective Action
The memory is full. Check the size of the data in the print job.
An HP-GL/2 command not supported by this printer was
received.
Check the print job and settings.
The printer has received print data that includes HP RTL
commands when Auto Rotate is On.
Set Auto Rotate to Off before attempting to print
again.
(See "Main Menu Settings.")
→P.679
Lines Are Printed Too Thick or Thin During HP-GL/2 Printing
Cause Corrective Action
The Line Width setting in
the main menu is incorrect.
Confirm the selection in Line Width. If fine lines are printed faint, setting Thick-
enFineLines to On in the main menu will print the lines more distinctly.
(See "Main Menu Settings.") →P.679
HP-GL/2 jobs are printed in monochrome (or color).
Cause Corrective Action
The Color Mode
is incorrect.
On the printer Control Panel, check the Color Mode setting.
(See "Main Menu Settings.") →P.679
However, for optimal Printhead performance, the printer consumes trace amounts of color ink
even when Monochrome is selected as Color Mode.
Printed Colors in Line Drawings are Inaccurate During HP-GL/2 Printing
Cause Corrective Action
AdjustFaintLines in the main
menu is set to On.
Selecting Off may help produce the expected results. However, lines in some
colors may appear broken.
Troubleshooting
>
HP-GL/2 problems
>
iPF825 Lines or images are missing in the HP-GL/2 data that was printed.
12
813
To Next Page
Loading...
