Canon iPF825 - Other Maintenance

Other Maintenance
Preparing to Transfer the Printer ............................................................................................................... 776
Updating the Firmware .............................................................................................................................. 782
Preparing to Transfer the Printer
To protect the internal parts in transit, always follow the steps below before transferring the printer to a new location.
Refer to the Setup Guide for details on packing the printer and installing it after transfer.
Important
• Be sure to contact your Canon dealer before transferring the printer to a new location. Ink may leak and
damage the printer if you do not prepare the printer correctly and it is tipped or stood on end in transit.
Note
• It
is not possible to prepare the printer for transfer if the Display Screen requests Maintenance Cartridge
replacement or checking of the remaining capacity. Replace the Maintenance Cartridge before transfer
preparations. (See "Replacing the Maintenance Cartridge.")
→P.763
• Depending
on the state of the printer, part replacement may be necessary when preparing to transfer the
printer (that is, when you execute the printer menu item to prepare for transfer).
• Ink must be drained before Level 2 or Level 3 printer transfer, as described in the following table. Pre-
pare a Maintenance Cartridge in advance.
• Always follow the instructions of the service representative when transferring the printer under Level 3
conditions.
Level
Shipping
Method (Ex-
ample)
Permitted Angle of Inclination
Amount of
Ink to Dis-
pose of
Required
Mainte-
nance Car-
tridges(*1)
1 By truck Lengthwise: 0°–30°
Rotation: 0°–10°
0 0 or 1
2 By plane All directions: 0°–30° Approx. 200
ml
1 or 2
3 Tipping the
printer or hold-
ing it upright
for elevators or
stairs
Lengthwise: 0°–90°
Rotation: 0°–30°
Approx. 700
ml
2 or 3
Maintenance
> Other Maintenance >
Preparing to Transfer the Printer iPF825
11
776