Canon iPF825 - Cutting Roll Paper after Printing (Mac os X)

Cutting Roll Paper After Printing (Mac OS X)
This topic describes how to cut roll paper automatically after printing (using the auto cut function), as well as how to
print a cut line for manual cutting.
Note
• The
auto cut function is activated on the printer by default and when the printer driver is installed. Fol-
low the steps below to reactivate the function if it is disabled, or to select the setting for printing a cut
line instead.
1. This sets the BFormat for and C Paper Size.
Note
• The configuration method varies depending on the OS and application software you are using.
If Page
Setup is displayed in the application menu, the settings are configured by opening the
Page Attributes dialog box from Page Setup.
If it is not displayed, the settings are configured in the upper part of the printer driver displayed
when you select Print from the application software menu.
2. Select the printer in the APrinter list.
3. Choose the original size in the CPaper Size list.
4. If
you configured the settings using the Page Attributes dialog box, click FOK to close the dialog box, and
then select Print from the application software menu.
Enhanced Printing Options
> Other useful settings >
Cutting Roll Paper After Printing (Mac OS X) iPF825
3
186