4. Execute the following command to send the IP address to the printer and configure it.
ping [IP address as specified in the ARP command] -l 479
Example: ping xxx.xxx.xxx.xxx -l 479
Note
• In -l, the l is the letter l.
• In
Mac OS X when using Terminal, enter the ping command in the format ping -s 479
xxx.xxx.xxx.xxx. For details, refer to the help file for the command line.
Note
• The subnet mask and default gateway will be set to 0.0.0.0. Use RemoteUI to change the subnet mask
and default gateway to match your network settings.
For details on RemoteUI, see "Using RemoteUI." →P.717
Using RemoteUI
Enter the printer's IP address in a web browser to display the RemoteUI page. After you log on to RemoteUI from the
page, you can check and change the status of the printer and print jobs, and configure network settings.
To access RemoteUI, start the web browser and enter the following URL in the Location (or Address ) box to display
the RemoteUI page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
For details on configuring printer settings for networks, refer to the following topics.
• Configuring the Printer's TCP/IP Network Settings →P.717
• Configuring the Printer's AppleTalk Network Settings →P.732
• Configuring the Printer's NetWare Network Settings →P.724
• Specifying Printer-Related Information →P.719
Note
• RemoteUI
also offers many other features. You can display the ink levels, check error messages and oth-
er status information, and cancel print jobs.
• By factory default, the English screen is displayed. To change the display language, select the desired
language under Language before logging on in administrator mode.
Important
• Use
Netscape Navigator 6.0 or later, Internet Explorer 5.01 or later, or Firefox 1.5 or later as a web
browser. In Mac OS X, you can also use Safari 1.32 or later or Safari 2.03 or later.
• Access is not possible via a proxy server. In environments where a proxy server is used, add the printer's
IP address to Exceptions (addresses accessed without a proxy server) in the web browser proxy server
settings. (Settings may vary depending on the network environment.)
• Enable JavaScript and cookies in the web browser.
• If you access RemoteUI with the printer name instead of its IP address, make sure the DNS settings are
correctly configured.
Configuring the Printer's TCP/IP Network Settings
Follow the steps below to configure the TCP/IP network settings.
1. Start
the web browser and enter the following URL in the Location (or Address ) box to display the RemoteUI
page.
http://printer IP address or name/
Example: http://xxx.xxx.xxx.xxx/
Network Setting
>
Network Setting
>
iPF825 Using RemoteUI
10
717
To Next Page
Loading...
