Canon iPF825 - Paper Size Not Detected

Cause Corrective Action
The roll width set in Fit Roll Paper Width in the
printer driver does not match the width of the roll
loaded in the printer.
Hold down the Stop button for a second or more to cancel
printing.
Make sure the roll width selected in the dialog box dis-
played when you select Fit Roll Paper Width in the print-
er driver matches the width of the roll loaded in the printer,
and then try printing again.
Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Follow these steps to reload the roll.
1. Lift the Release Lever.
2. Open the Top Cover.
3. Adjust
the right edge of the roll to make it
parallel to the right Paper Alignment Line.
4. Lower the Release Lever.
5. Close the Top Cover.
6. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the
page on which the error occurred.
(See "Loading Rolls in the Printer.")
→P.588
If this error recurs after you reload the roll, re-
move the Roll Holder from the printer, push
the roll firmly in until it touches the Roll
Holder flange, and reload the Roll Holder in
the printer.
(See "Attaching the Roll Holder to Rolls.")
→P.584
Follow these step to reload a sheet.
1. Lift the Release Lever.
2. Open the Top Cover.
3. Adjust
the right edge of the sheet to make
it parallel to the right Paper Alignment
Line and the trailing edge of the sheet to
make it parallel to the paper alignment line
under the Paper Retainer.
4. Lower the Release Lever.
5. Close the Top Cover.
6. If "Not finished printing. Finish printing
remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the
page on which the error occurred.
(See "Loading Sheets in the Printer.")
→P.616
Error Message
> Messages regarding paper >
iPF825 Paper size not detected.
13
825