xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1085
Example
To configure voice VLAN ports 1:4-1:6 to enable:
DGS-3120-24TC:admin#config voice_vlan ports 1:4-1:6 state enable
Command: config voice_vlan ports 1:4-1:6 state enable
Success.
To set the mode auto to voice VLAN ports 1:3-1:5:
DGS-3120-24TC:admin#config voice_vlan ports 1:3-1:5 mode auto
Command: config voice_vlan ports 1:3-1:5 mode auto
Success.
119-6 config voice_vlan aging_time
Description
This command is used to set the aging time of the voice VLAN. The aging time is used to remove
a port from voice VLAN if the port is an automatic VLAN member. When the last voice device
stops sending traffic and the MAC address of this voice device is aged out, the voice VLAN aging
timer will be started. The port will be removed from the voice VLAN after expiration of the voice
VLAN aging timer.
If the voice traffic resumes during the aging time, the aging timer will be stopped and reset.
Format
config voice_vlan aging_time <min 1-65535>
Parameters
aging_time - The aging time to set. The default value is 720 minutes.
<min 1-65535> - Enter the aging time value here. This value must be between 1 and 65535.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To set 60 minutes as the aging time of voice VLAN:
To Next Page
Loading...
Need help?
General
