D-Link xStack DGS-3120 Series - Page 1091

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1086
DGS-3120-24TC:admin# config voice_vlan aging_time 60
Command: config voice_vlan aging_time 60
Success.
DGS-3120-24TC:admin#
119-7 config voice_vlan log state
Description
This command is used to configure the log state for voice VLAN. If there is a new voice device
detected/or a port joins/leaves the voice VLAN dynamically, and the log is enabled, a log will be
triggered.
Format
config voice_vlan log state [enable | disable]
Parameters
enable - Specify that the sending of a voice VLAN log will be enabled.
disable - Specify that the sending of a voice VLAN log will be disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the log state for voice VLAN:
DGS-3120-24TC:admin#config voice_vlan log state enable
Command: config voice_vlan log state enable
Success.
DGS-3120-24TC:admin#
119-8 show voice_vlan
Description
This command is used to show the voice VLAN global information.
Format
show voice_vlan
Parameters
None.