D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
223
19-24 show cfm remote_mep
Description
This command is used to show remote MEPs.
Format
show cfm remote_mep [mepname <string 32> | md [<string 22> | md_index <uint 1-
4294967295>] ma [<string 22> | ma_index <uint 1-4294967295>] mepid <int 1-8191>]
remote_mepid <int 1-8191>
Parameters
mepname - Specify the MEP name used.
<string 32> - Enter the MEP name used. This name can be up to 32 characters long.
md Specify the maintenance domain name.
<string 22> - Enter the maintenance domain name. This name can be up to 22 characters
long.
md_index - Specify the maintenance domain index.
<uint 1-4294967295> - Enter the maintenance domain index value. This value must
between 1 and 4294967295.
ma Specify the maintenance association name.
<string 22> - Enter the maintenance association name. This name can be up to 22
characters long.
ma_index - Specify the maintenance association index.
<uint 1-4294967295> - Enter the maintenance association index value here. This value
must between 1 and 4294967295.
mepid - Specify the MEP ID used.
<int 1-8191> - Enter the MEP ID used. This value must be between 1 and 8191.
remote_mepid - Specify the Remote MEP ID used.
<int 1-8191> - Enter the remote MEP ID used. This value must be between 1 and 8191.
Restrictions
None.
Example
To show the CFM Remote MEP information:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)