D-Link xStack DGS-3120 Series - Page 244

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
239
delete - Specify to delete a rule from the profile ID entered.
access_id - Specify the index of access list entry. The range of this value is 1-100.
<value 1-100> - Enter the access ID here. This value must be between 1 and 100.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure CPU access list entry:
DGS-3120-24TC:admin# config cpu access_profile profile_id 1 add access_id 1 ip
vlan default source_ip 20.2.2.3 destination_ip 10.1.1.252 dscp 3 icmp type 11
code 32 port 1 deny
Command: config cpu access_profile profile_id 1 add access_id 1 ip vlan default
source_ip 20.2.2.3 destination_ip 10.1.1.252 dscp 3 icmp type 11 code 32 port 1
deny
Success.
DGS-3120-24TC:admin#
21-4 enable cpu interface filtering
Description
This command is used to enable CPU interface filtering control.
Format
enable cpu_interface_filtering
Parameters
None.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To enable cpu_interface_filtering:
DGS-3120-24TC:admin# enable cpu_interface_filtering
Command: enable cpu_interface_filtering
Success.
DGS-3120-24TC:admin#