D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
282
22-47 debug vrrp show log state (RI Mode Only)
Description
The command is used to display the VRRP debug log state.
Format
debug vrrp show log state
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the VRRP debug log state:
DGS-3120-24TC:admin#debug vrrp show log state
Command: debug vrrp show log state
VRRP Debug Log State : Enabled
DGS-3120-24TC:admin#
22-48 debug vrrp state (RI Mode Only)
Description
The command is used to enable or disable the VRRP debug state.
Format
debug vrrp state [enable | disable]
Parameters
enable - Specify that the VRRP debug state will be enabled.
disable - Specify that the VRRP debug state will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the VRRP debug state:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)