D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
283
DGS-3120-24TC:admin#debug vrrp state enable
Command: debug vrrp state enable
Success.
DGS-3120-24TC:admin#
22-49 debug pim ssm (RI Mode Only)
Description
This command is used to enable the PIM-SSM debug function.
Format
debug pim ssm
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the PIM-SSM debug function:
DGS-3120-24TC:admin#debug pim ssm
Command: debug pim ssm
Success.
DGS-3120-24TC:admin#
Once the PIM-SSM debug enabled, the debug information maybe outputted.
DGS-3120-24TC:admin#PIM_SSM, 29 Oct 2012 11:04:12 IGMP v1/v2 Report for group
232.1.1.0 from 192.168.121.1 on n121, ignored.
Output truncated...
22-50 no debug pim ssm (RI Mode Only)
Description
This command is used to disable the PIM-SSM debug function.
Format
no debug pim ssm

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)