D-Link xStack DGS-3120 Series - Page 338

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
333
Format
show dhcp pool manual_binding {<pool_name 12>}
Parameters
<pool_name 12> - (Optional) Specify the DHCP pool name.
Restrictions
None.
Example
To display the configured manual binding entries:
DGS-3120-24TC:admin#show dhcp pool manual_binding
Command: show dhcp pool manual_binding
Pool Name IP Address Hardware Address Type
--------- --------- ------------------------ ---------
dhcppool01 10.10.10.1 00-80-C8-02-02-02 ethernet
Total Entries: 1
DGS-3120-24TC:admin#
26-23 enable dhcp_server
Description
This command is used to enable the DHCP server function.
If DHCP relay is enabled, DHCP server cannot be enabled. The opposite is also true. For Layer 2
switches, if DHCP client is enabled on the only interface, then DHCP server cannot be enabled.
For layer 3 switches, when the System interface is the only interface then can DHCP client be
enabled. If the DHCP client is enabled, then the DHCP server cannot be enabled.
Format
enable dhcp_server
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.