D-Link xStack DGS-3120 Series - Page 398

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
393
To configure the state of topology change propagation:
DGS-3120-24TC:admin# config erps raps_vlan 4094 sub_ring raps_vlan 4093
tc_propagation state enable
Command: config erps raps_vlan 4094 sub_ring raps_vlan 4093 tc_propagation
state enable
Success.
DGS-3120-24TC:admin#
35-6 config erps log
Description
This command is used to configure the log state of ERPS events.
Format
config erps log [enable | disable]
Parameters
log - Specify to enable or disable the ERPS log state.
enable - Enter enable to enable the log state.
disable - Enter disable to disable the log state. The default value is disabled.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the ERPS log state:
DGS-3120-24TC:admin# config erps log enable
Command: config erps log enable
Success.
DGS-3120-24TC:admin#
35-7 config erps trap
Description
This command is used to configure trap state of ERPS events.
Format
config erps trap [enable | disable]