D-Link xStack DGS-3120 Series - Page 487

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
482
43-23 show address_binding nd_snoop binding_entry
Description
This command is used to show the ND snooping binding entries on the Switch.
Format
show address_binding nd_snoop binding_entry {port <port>}
Parameters
port - (Optional) Specify a port used for this display.
<port> - Enter the port number used for this display here.
Restrictions
None.
Example
To show the ND snooping binding entry:
DGS-3120-24TC:admin#show address_binding nd_snoop binding_entry
Command: show address_binding nd_snoop binding_entry
S (Status) - A: Active, I: Inactive
Time - Left Time (sec)
IP Address MAC Address S LT(sec) Port
--------------------------------------- ----------------- -- ---------- -----
2001:2222:1111:7777:5555:6666:7777:8888 00-00-00-00-00-02 I 50 5
2001::1 00-00-00-00-03-02 A 100 6
Total Entries : 2
DGS-3120-24TC:admin#
43-24 clear address_binding nd_snoop binding_entry ports
Description
This command is used to clear the ND snooping entries on specified ports.
Format
clear address_binding nd_snoop binding_entry ports [<portlist> | all]
Parameters
ports - Specify the list of ports that you would like to clear the ND snoop learned entry.
<portlist> - Enter the list of port used here.
all - Clear all ND snooping learned entries.