xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
638
Command: show mld_snooping
MLD Snooping Global State : Disabled
VLAN Name : default
Query Interval : 125
Max Response Time : 10
Robustness Value : 2
Last Listener Query Interval : 1
Querier State : Disabled
Querier Role : Non-Querier
Querier IP : ::
Querier Expiry Time : 0 secs
State : Disabled
Fast Done : Disabled
Rate Limit(pkt/sec) : No Limitation
Proxy Reporting : Disabled
Proxy Reporting Source IP : ::
Version : 2
Total Entries: 1
63-8 show mld_snooping group
Description
This command is used to display the current MLD snooping group information on the Switch.
Format
show mld_snooping gr
oup {[vlan <vlan_
name 32> | vlanid <vlanid_l
ist> | ports <portlist>
]
{<ipv6addr>}} {data_driven}
Parameters
vlan - (Optional) Specify the name of the VLAN for which you want to view MLD snooping group
information. If VLAN and ports and IP address are not specified, the system will display all
current IGMP snooping group information.
<vlan_name 32> - Enter the VLAN name here. The VLAN name can be up to 32 characters
vlanid - (Optional) Specify the ID of the VLAN for which you want to view MLD snooping group
<vlanid_list> - Enter the VLAN ID list here.
ports - (Optional) Specify a list of ports for which you want to view MLD snooping group
<portlist> - Enter the list of port here.
<ipv6addr> - (Optional) Specify the group IPv6 address for which you want to view MLD
snooping group information.
data_driven - (Optional) Display the data driven groups. (EI and SI Mode Only)
To Next Page
Loading...
Need help?
General
