D-Link xStack DGS-3120 Series - Page 820

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
815
Example
To create a static RP:
DGS-3120-24TC:admin#create pim6 static_rp group FF02::11/64 rp 3000::12
Command: create pim6 static_rp group FF02::11/64 rp 3000::12
Success.
DGS-3120-24TC:admin#
81-16 delete pim6 static_rp group
Description
This command is used to delete a static RP.
Format
delete pim6 static_rp group <ipv6networkaddr>
Parameters
<ipv6networkaddr> - Specify the multicast group network address for this static RP.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To delete a static RP:
DGS-3120-24TC:admin#delete pim6 static_rp group FF02::11/64
Command: delete pim6 static_rp group FF02::11/64
Success.
DGS-3120-24TC:admin#
81-17 config pim6 embedded_rp state
Description
This command is used to configure the state of the embedded RP.
Format
config pim6 embedded_rp state [enable | disable]
Parameters
enable - Specify to enable embedded RP support in PIM6.