D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
882
DGS-3120-24TC:admin#show route redistribute dst ospf
Command: show route redistribute dst ospf
Route Redistribution Settings
Source Destination Type Metric RouteMapName
Protocol Protocol
-------- ------------ -------- ------ ------------
RIP OSPF Type-1 2 N/A
Total Entries : 1
DGS-3120-24TC:admin#
89-13 show route redistribute dst rip (RI Mode Only)
Description
This command is used to the redistribution with the target protocol RIP.
Format
show route redistribute dst rip {src [local | static | ospf]}
Parameters
src - (Optional) Specify the source protocol.
local - Display the redistribution with the source local.
static - Display the redistribution with the source static.
rip - Display the redistribution with the source protocol RIP.
Restrictions
None.
Example
To display the redistribution with the target protocol RIP:
DGS-3120-24TC:admin#show route redistribute dst rip
Command: show route redistribute dst rip
Route Redistribution Settings
Source Destination Type Metric RouteMapName
Protocol Protocol
-------- ------------ -------- ------ ------------
OSPF RIP Internal 2 N/A
Total Entries : 1
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)