xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
895
Example
To show all backup schedules:
DGS-3120-24TC:admin#show backup
Command: show backup
Backup Schedule Entry 1
Time Range : range_1
Type : configuration
Filename : c:/bk-config-1
State : Disabled
Total Entries1
92-5 create execute_config time_range
Description
This command is used to create a schedule to execute the configuration on file system. If the time
range does not exist, the schedule will still be created without prompt. But the schedule will not
take effective until the time range is created. To create an existed entry, the device will feedback a
success message and does no change for the existed schedule. The maximum of schedules
execute is 15.
Format
create ex
ecute_co
nfig ti
me_r
ange
<range_nam
e 32>
config
<pathn
ame> {
state [enab
le |
disable] | [increment | reset]}
Parameters
<range_name32> - Enter the time range for schedule to execute the configuration. Maximum 32
characters.
config - The filename of the configuration on file system.
<pathname> - Enter the configuration file path name.
state - (Optional) Enable or disable the executive schedules when the schedule is created.If not
specified, the schedule will be disabled.
enable – Enable the executive schedule.
disable – Disable the executive schedule.
increment - (Optional) The current configuration will not be reset before executing the
configuration.
reset - (Optional) The current configuration will be reset before executing the configuration.
Restrictions
Only Administrator-level users can issue this command.
Example
To create a schedule to execute the configuration on file system:
To Next Page
Loading...
Need help?
General
