D-Link xStack DGS-3120 Series - Page 901

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
896
DGS-3120-24TC:admin#create execute_config time_range range-1 config c:/vlan-
config state enable
Command: create execute_config time_range range-1 config c:/vlan-config state
enable
Success.
DGS-3120-24TC:admin#
92-6 config execute_config time_range
Description
This command is used to configure configuration state or execute method of a executive schedule.
Format
config execute_config time_range <range_name 32> config <pathname> {state [enable |
disable] | [increment | reset]}
Parameters
<range_name32> - Enter the time range for schedule to execute the configuration. Maximum 32
characters.
config - The filename of the configuration on file system.
<pathname> - Enter the configuration file path name.
state - (Optional) Enable or disable the executive schedules.
enable – Enable the executive schedule.
disable – Disable the executive schedule.
increment - (Optional) The current configuration will not be reset before executing the
configuration.
reset - (Optional) The current configuration will be reset before executing the configuration.
Restrictions
Only Administrator-level users can issue this command.
Example
To configure a executive schedule:
DGS-3120-24TC:admin# config execute_config time_range range_1 config c:/system-
config state enable increment
Command: config execute_config time_range range_1 config c:/system-config state
enable increment
Success.
DGS-3120-24TC:admin#