154 01-6203-01R3, CG Drives & Automation
Performing optimisation with keypad
Since there is no access with the keypad to the motor catalogue, first the motor data must
be set manually with the keypad according to the manufacturer data/motor data sheet.
Man- ual setting of the motor data
108
The following flow diagram shows the optimisation process with the keypad:
• If the application enables you to energise the system during the optimisation
procedure, carry out an automatic identification. This procedure results in the best
possible parameter settings. Automatic motor identification (energized)
139
• If the application does not enable you to energise the system during the optimisation
procedure, carry out an automatic calibration. Automatic motor calibration (non-
energized)
140
To Next Page
Loading...
