3-76 Phaser 5500 Printer Service Manual
Jam at B - C8-2 F/O3 SNR Static Jam
Paper remains at Feed Out Sensor #3 located behind Door B.
Applicable Error Code
Jam at B - C8-2 F/O3 SNR Static Jam
Jam at B (Feed Out #3 Sensor) Troubleshooting Reference
Applicable Parts References
■ Feed Out Sensor #3
■ Tray 3 Feed/Lift Motor
■ Engine Logic Board
■ Print Engine P/J Tray 2 & 3 Feeder (page 10-11)
■ Print Engine Registration Transport Wiring
(page 10-23)
■ PL2.3 Feeder (2/2) (page 9-12)
■ PL4.5 Registration (page 9-30)
■ PL8.1 Print Engine Electrical (page 9-40)
Jam at B (Feed Out #3 Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check the paper path.
Open Door B.
Does the paper touch the Tray 3 Feed
Out Sensor?
Remove the
paper.
Go to Step 2.
2
Test the Feed Out Sensor #3.
1. Open Door B.
2. Run the Service Diagnostics Tray 3
Feed Out Sensor test.
Does the sensor change state?
Replace the
Engine Logic
Board (
8-89).
Go to Step 3.
3
Check the sensor connection.
Are P/J105, P/J608, and P/J410
connected?
Go to Step 4. Connect the
sensor.
4
Check continuity between the sensor and
Engine Logic Board.
Is there continuity on each wire
between P/J105 <=> P/J410?
Go to Step 5. Repair the wiring.
5
Check for +5 V to the Feed Out Sensor #3.
Is there +5 V across P105-1(+)<=>
ground?
Replace the Feed
Out Sensor #3
(
page 8-54).
Replace the
Engine Logic
Board
(
page 8-89).
To Next Page
Loading...
