Adjustments and Calibrations 6-9
Resetting Fuser Life
This procedure restarts the counter that tracks Fuser life. Perform this procedure after
you install a new Maintenance Kit.
Note
Resetting the Fuser Life counter also resets the Transfer Roller counter and all
Tray Page counters to zero.
To reset the Fuser:
1. From the Main menu, select Information, then press the OK button.
2. Select Supplies Info, then press the OK button.
3. Select Reset Fuser Life, then press the OK button.
4. Select Reset Fuser Life NOW, then press the OK button to reset the fuser life.
Resetting the Printer to Default Values
You can reset printer values on the following menus to the factory default settings:
■ Connection Setup
■ Paper Handling Setup
■ PostScript Setup
■ PCL Setup
■ General Setup
■ Front Panel Setup
■ Printer Controls
■ File Security (available if the printer has a hard drive)
You can reset all of the Image Processor Board NVRAM-stored parameters to their
factory default values by resetting the PostScript NVRAM. Instructions for resetting
PostScript NVRAM are in
"Resetting Printer Default Settings (PostScript NVRAM)"
on page 6-12.
Note
There is no single reset for the Print Engine NVRAM.
To Next Page
Loading...
