Error Messages, Codes, and Procedures 3-5
POST Soft Fault Messages
When POST detects a soft error, the printer continues the startup process. Before the
printer reaches its “Ready to Print” state, the Start Page is printed with soft errors
appearing in a gray box. The box contains all soft faults encountered, with the upper
left corner of the box in the center of the Start Page, and extending to the right margin,
similar to the one shown here.
These messages are substituted for <device>:
■ Real Time Clock
■ RAM Memory Slot 1 Checksum
■ RAM Memory Slot 2 Checksum
■ RAM Memory Slot 1 Rejected
■ RAM Memory Slot 2 Rejected
■ IDE Disk
For Real Time Clock errors, replace the Image Processor Board. For IDE Disk errors,
replace the Hard Drive. For memory errors, see
"RAM Memory Fault Isolation" on
page 4-15.
Hardware Failure:
<device>:
General Failure
To Next Page
Loading...
Need help?
General
