8-4 Phaser 5500 Printer Service Manual
Caution
Always use the correct type and size screw. Using the wrong screw can damage
tapped holes. Do not use excessive force to either remove or install either a screw
or a printer part.
Caution
Do not remove red screws. Frame mis-alignment will result.
arn
ng
Unplug the AC power cord from the wall outlet before removing any printer part.
Notations in the Disassembly Text
■ The notation “PLX.X.X” at the top of each Figure references the FRU parts list
containing this part or assembly.
■ Page number references are given in-line for procedural steps previously
described.
■ Bold arrows in an illustration show direction of movement when removing or
replacing a component.
■ Numbered arrows indicate manipulation steps for removal of the part.
To Next Page
Loading...
Need help?
General
