Fuji Xerox Phaser 5500 User Manual

xviii Phaser 5500 Printer Service Manual
Servicing Electrical Components
Before starting any service procedure, switch off the printer power and unplug the
power cord from the wall outlet. If you must service the printer with power applied,
be aware of the potential for electrical shock.
W
arn
i
ng
Turning the power off by using the On/Off switch does not completely de-
energize the printer. You must also disconnect the printer power cord from the
AC outlet. Position the power cord so that it is easily accessible during servicing.
W
arn
i
ng
Do not touch any electrical component unless you are instructed to do so by a
service procedure.
Servicing Mechanical Components
When servicing mechanical components within the printer, manually rotate drive
assemblies, rollers, and gears.
W
arn
i
ng
Do not try to manually rotate or manually stop the drive assemblies while any
printer motor is running.
Servicing Fuser Components
W
arn
i
ng
This printer uses heat to fuse the toner image to media. The Fuser is VERY HOT.
Turn the printer power off and wait at least 5 minutes for the Fuser to cool before
you attempt to service the Fuser or adjacent components.
S7300-02
S7300-03

Fuji Xerox Phaser 5500 Specifications

General

Brand	Fuji Xerox
Model	Phaser 5500
Category	Printer
Language	English