3-106 Phaser 5500 Printer Service Manual
Jam at G - F4-4n Buffer Path SNR Static
Remaining paper is detected in the Buffer Path by the Buffer Path Sensor.
Applicable Error Codes
Jam at G - F4-46 Buffer Path SNR Static Jam A
Jam at G - F4-47 Buffer Path SNR Static Jam B
Jam at G - F4-48 Buffer Path SNR Static Jam C
44
Print a Test Print.
Does the error still occur?
Go to Step 45. Problem solved.
45
Check Buffer Sensor Harness continuity.
1. Disconnect P/J8392 and P/J8318B.
2. Check for continuity at the following:
J8392-3 <=> J8318B-1
J8392-2 <=> J8318B-2
J8392-1 <=> J8318B-3
Are these conductive?
Go to Step 46. Repair the Buffer
Sensor Harness.
46
Check Main Sensor Harness continuity.
1. Disconnect P/J8318A from the harness,
and P/J8302A on the Finisher Main
PWB.
2. Check for continuity at the following:
J8318A-3 <=> J8302A-13
J8318A-2 <=> J8302A-14
J8318A-1 <=> J8302A-15
Are these conductive?
Go to Step 47. Repair the Main
Sensor Harness.
47
Check for +5 V to the Buffer Path Sensor.
Is there +5 V across J8302A-15 <=>
J8302A-13 on the Finisher Main PWB?
Go to Step 48. Replace the
Finisher Main
PWB
(
page 3-248).
48
Check Buffer Path Sensor signal.
Does the voltage across P8302A-14 <=>
P8302A-13 on the Finisher Main PWB
change when the actuator is operated?
Replace the
Finisher Main
PWB
(
page 3-248).
Replace the
Buffer Path
Sensor
(
page 3-207).
Jam at G (Buffer Path Sensor ON) Troubleshooting Procedure (Continued)
Step Actions and Questions Yes No
To Next Page
Loading...
Need help?
General
