8-94 Phaser 5500 Printer Service Manual
6. Disconnect the three connectors (P2, J11 (Black wire), J12 (White wire) from the
LVP S.
7. Release the four harnesses from the three clamps.
8. Remove the three screws securing the AC Accessory Panel to the printer.
9. Release the harness from the clamp.
10. Remove the AC Accessory Panel.
GFI Breaker
1. Remove the I/P Board Cover (page 8-14).
2. Remove the Upper Rear Cover (page 8-15).
3. Remove the Lower Rear Cover (page 8-16).
PL8.1.13
4. Remove the three screws securing the AC Accessory Panel to the frame.
5. Disconnect the two connectors from the GFI Breaker.
6. Remove the two screws securing the GFI Breaker to the AC Accessory Panel.
GFI Breaker
s5500-188
To Next Page
Loading...
