Error Messages, Codes, and Procedures 3-159
Finisher Board Failure - H5-4, 7, 8 NVM/Comm/Type
Error
Applicable Error Codes
Finisher Board Failure - H5-4 NVM R/W Error
Finisher Failure - H5-7 MCU-Finisher Comm Error
Incorrect Finisher Installed - H5-8 Finisher Type Error
10
Check for +5 V to the Tray 4-5 PWB
Is there +5 V across P/J413-A5 (+) <=>
ground?
Replace the
Tray
4-5 PWB
(
page 3-29).
Replace the
Engine Logic
Board
(
page 8-89).
Finisher Board Error (NVRAM R/W Error) Troubleshooting Reference
Applicable Parts References
■ Finisher Main PWB
■ Engine Logic
Board
■ Print Engine P/J Engine Logic Board (page 10-13)
■ PL8.1 Print Engine Electrical (page 9-40)
■ Phaser 5500 Printer Options Service Manual
■ Finisher Main PWB P/J Locator (page 5-35)
■ PL25.14 Finisher Electrical (page 4-70)
Finisher Board Error (NVRAM R/W Error) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check the Finisher installation.
Are the interface cables connected
correctly?
Go to Step 2. Reconnect the
cables and got to
Step 2.
2
Does the error occur when the power is
cycled?
Go to Step 2. Problem solved.
3
Check Finisher Main PWB connections.
Are P/J8300 and P416 connected?
Go to Step 3. Connect all
connectors. Go to
Step 3.
Paper Size Failure (Tray 4-5 Paper Size Switch) Troubleshooting Procedure
Step Actions and Questions Yes No
To Next Page
Loading...
