1-6 Phaser 5500 Printer Service Manual
Printer Options
Phaser 5500 printer options include:
■ 20 GB Hard Drive
■ Additional RAM and NVRAM
■ Exit 2
■ Configuration Card
■ 1000-Sheet Feeder (Tray 4 & 5)
■ Duplex Unit
■ 3,500-Sheet Stacker (with offset)
■ 3,500-Sheet Finisher (with hole punch, staple, offset)
■ 2,000-Sheet Feeder (Tray 6)
■ Envelope Tray (replaces Tray 2)
Hard Drive
A 20 GB hard drive is available to enable the Job Collation, Saved Jobs, Proof,
Personal, and Secure Print options. The hard drive installs on the Image Processor
Board with stand-offs and connects to the board with a single data/power connector.
Additional Memory
Options provide additional RAM in 128 MB and 256 MB increments. Also available
is 16 MB of Flash Memory for fonts, forms, and macros. Both RAM and NVRAM
options install to the Image Processing board. The Startup Page and Configuration
Page list the amount of installed RAM.
See “Memory Specifications” on page 1-11.
Exit 2
Exit 2 is required when either the Duplex Unit or Stacker/Finisher is installed. When
used in conjunction with the Duplex Unit, Exit 2 performs as a paper inverter. With
the Stacker/Finisher, Exit 2 serves as the replacement face-down exit to the top tray.
Exit 2 mounts directly above Exit 1 with spring loaded latches and guide pins.
Networking
A Configuration Card is used to enable or disable networking capabilities. This option
provides a replacement card to enable Ethernet on the base model (Phaser 5500B
printer).
To Next Page
Loading...
Need help?
General
