Error Messages, Codes, and Procedures 3-243
Close Door F - Door F is Open
The Door F Interlock Sensor in the Horizontal Transport indicates Door F is open.
Door F Open (Door F Interlock Switch) Troubleshooting Reference
Applicable Parts References
■ H-X’port Top Cover
■ Door F Interlock
Sensor
■ H-X’port Harness
■ H-X’port PWB
■ Finisher Main
PWB
■ Engine Logic
Board.
■ Print Engine P/J Engine Logic Board (page 10-13)
■ PL8.1 Print Engine Electrical (page 9-40)
■ Phaser 5500 Printer Options Service Manual
■ Horizontal Transport P/J Locator (page 5-29)
■ Finisher Main PWB P/J Locator (page 5-35)
■ Horizontal Transport Wiring (page 5-39)
■ PL25.2 Horizontal Transport (1/2) (page 4-46)
■ PL25.3 Horizontal Transport (2/2) (page 4-48)
■ PL25.14 Finisher Electrical (1/2) (page 4-70)
Door F Open (Door F Interlock Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check Door F operation.
Does Door F open and close smoothly?
Go to Step 2. Correct the
installation.
2
Check the Door F Interlock Sensor
Actuator.
Is the actuator damaged?
Replace the Top
Cover
(
page 3-108).
Go to Step 3.
3
Check the Door F Interlock Sensor
installation.
Is the sensor installed correctly?
Go to Step 4. Correct the
installation.
4
Test the sensor.
Run the Service Diagnostics Door F
Interlock Sensor test.
Does the sensor state change when
Door F is opened and closed?
Go to Step 11. Go to Step 5.
5
Check the Door F Interlock Sensor
Harness connections.
Are P/J8382 of the harness, and P/
J8372 on the H-X’port PWB connected?
Go to Step 7. Connect and go
to Step 6.
6
Cycle printer power.
Does the error still occur?
Go to Step 7. Problem solved.
To Next Page
Loading...
