Fuji Xerox Phaser 5500

Error Messages, Codes, and Procedures 3-153
Exit Comm Failure Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check the Exit PWB connection.
Are P/J431 and P/J421 connected?
Go to Step 2. Connect P/J431
and P/J421.
2
Check continuity between the Exit PWB
and the Engine Logic Board.
1. Disconnect P/J431 and P/J421.
2. Check for continuity at the following:
P/J431-1 <=> P/J421-8
P/J431-2 <=> P/J421-7
P/J431-3 <=> P/J421-6
P/J431-4 <=> P/J421-5
P/J431-5 <=> P/J421-4
P/J431-6 <=> P/J421-3
P/J431-7 <=> P/J421-2
P/J431-8 <=> P/J421-1
Are these conductive?
Go to Step 3. Repair the wiring.
3
Check the connection between the Exit
PWB and the LVPS.
Are P/J430 and P/J526 connected?
Go to Step 4. Connect P/J430
and P/J526.
4
Check continuity between the Exit PWB
and the LVPS.
1. Disconnect P/J430 and P/J526.
2. Check for continuity at the following:
P/J430-3 <=> P/J526-6
P/J430-4 <=> P/J526-5
P/J430-1 <=> P/J526-8
P/J430-2 <=> P/J526-7
Are these conductive?
Go to Step 5. Repair the wiring.
5
Check for +24 V to the Exit PWB.
Is there +24 V across P/J430-1 (+) <=>
ground?
Replace the Exit
PWB (
page 8-88).
Replace the
LVPS
(
page 8-92).