Error Messages, Codes, and Procedures 3-179
Eject Clamp (Set Clamp Home Sensor) Troubleshooting Reference
Applicable Parts References
■ Set Clamp Home
Sensor
■ Main Sensor Harness
■ Finisher Main PWB
■ Eject Bracket
Assembly
■ Main Drive Harness
■ Set Clamp Clutch
■ Phaser 5500 Printer Options Service Manual
■ Finisher Main PWB P/J Locator (page 5-35)
■ Finisher Compiler P/J Locator (page 5-33)
■ Finisher Sensors (2/2) Wiring (page 5-41)
■ Finisher Clutch and Solenoids Wiring (page 5-43)
■ PL25.10 Finisher Eject (2/3) (page 4-62)
■ PL25.14 Finisher Electrical (page 4-70)
■ PL25.15 Finisher Harness (page 4-72)
Eject Clamp (Set Clamp Home Sensor) Troubleshooting Procedure
Step Actions and Questions Yes No
1
Check the Eject Clamp operation.
Rotate the Eject Clamp Motor.
Does the Eject Clamp move smoothly?
Go to Step 2. Correct the
installation.
2
Test the Set Clamp Home Sensor.
Run the Service Diagnostics Set Clamp
Home Sensor test.
Does the sensor change state?
Go to Step 8. Go to Step 3.
3
Check the Set Clamp Home Sensor
Harness connection.
Are P/J8325 and P/J8302B connected?
Go to Step 5. Connect and go
to Step 4.
4
Print a Test Print.
Does the error still occur?
Go to Step 5. Problem solved.
5
Check the Set Clamp Home Sensor
Harness continuity.
1. Disconnect P/J8325 and P/J8302B.
2. Check for continuity at the following:
P/J8325-3 <=> P/J8302B-4
P/J8325-2 <=> P/J8302B-9
P/J8325-1 <=> P/J8302B-11
Are these conductive?
Go to Step 6. Repair the Set
Clamp Home
Sensor Harness.
6
Check for +5 V to the Set Clamp Home
Sensor.
Is there +5 V across J8302B-11 <=>
J8302B-9 on the Finisher Main PWB for
H5-83?
Is there +5 V across J8302B-4 <=>
J8302B-9 on the Finisher Main PWB for
H5-84?
Go to Step 7. Replace the
Finisher Main
PWB
(
page 3-248).
To Next Page
Loading...
