Adjustments and Calibrations 6-13
Using the Service Diagnostics Menu
1. Enter Service Diagnostics.
2. Select IP NVRAM Access, then press the OK button.
3. With PostScript NVRAM Reset highlighted, press the OK button.
4. When Resetting NVRAM! Are you sure? is displayed, highlight Yes and
press the OK button.
The printer then exits Service Diagnostics and reboots. While booting, NVRAM
is reset.
Using the Front Panel Shortcut
1. At power-on, press the Back + OK buttons together.
2. When Password appears, press and hold the Up Arrow + Down Arrow buttons
together within 2 seconds.
To Next Page
Loading...
Need help?
General
