FRU Disassembly 8-85
6. Remove the Main Drive Belt (page 8-83).
PL7.1.7
7. Disconnect the two connectors from the Motor Assembly.
8. Remove the two screws securing the Take Away Clutch bracket to the frame and
to the Motor Assembly to remove the bracket.
9. Remove the four screws securing the Motor Assembly to the frame.
Replacement Note
Install the Motor Assembly by pushing the Gear on the upper part of the
Motor in the direction of the arrow.
Motor Assembly
Main Drive Belt
Take Away Clutch Bracket
CN101
CN102
Exit Flange
s5500-178
To Next Page
Loading...
