Creating and Editing Samples
Page 31
Creating New Sounds With The Sample Editor
Whether you are using sounds you have sampled yourself
or commercially produced sounds, the procedure for loading
them and assembling them in the Sample Editor is the same.
Press the PRESET button
in SECTION EDIT and
then select SAMPLE
EDITOR. Press ENTER to
see the main Sample
Editor window.
Now you are ready to
load your first sample.
Press LOAD (F1) and you
will see a display similar
to the DISK menu.
Locate and select the first sample you want to load from
either the floppy disk, hard disk, or CD. Select the sample
and then press ENTER.
Now youve loaded a single sample and you can see it at
the top of the Sample List. This list can contain up to 16
samples at the same time. These 16 samples can be mapped
to different regions of the keyboard and then saved as a
single Genesys Ensemble waveform when youve finished.
If you want to load another sample at this time, move the
cursor down to the second line of the SAMPLE LIST, press
LOAD, (F1) and proceed as before.
To Next Page
Loading...
Need help?
General
