Flywheel and clutch
64
2. Prior to the installation, clean the bolt threads and hole. As shown in the following Fig.,
smear evenly the sealant on the threads.
Attention
l It is unnecessary to smear sealant when a new bolt is used
3. Pre-tighten manually the flywheel bolt.
4. Fit the special tools on the flywheel (as shown in Fig.).
5. Gradually tighten the flywheel bolt according to criss cross order (as shown in Fig.).
Assembly instructions of pilot bearing
Attention
l Fit the pilot bearing as per the following instructions.
Mounting depth of pilot bearing: 0～0.4mm{0～0.115in}
Use as special tool (as shown in Fig.) to install a new pilot bearing.
It
is necessary to smear sealant
when the bolt is reused.
Gear ring fixture component
To Next Page
Loading...