HAIMA 7 - Driver-Sided Safety Airbag Module; Occupant-Sided Safety Airbag Module

Safety airbag system
T-54
Attention
The release of safety airbag module and
pretensioning safety belt inside the vehicle may
result in the internal damage. If the vehicle is not
going to be scrapped, do not release the safety
airbag module and pretensioning safety belt inside
the vehicle. When the vehicle is going to be
scrapped, the inside releases of safety airbag module
and pretensioning safety belt shall refer to
T—Release Procedures Inside Vehicle (only when
the vehicle is going to be scrapped).
When the vehicle is not scrapped, the outside
releases of the safety airbag module and
pretensioning safety belt shall refer to T—Release
Procedure Outside Vehicle.
Attention
When the released safety airbag module and
pretensioning safety belt are handled, please refer to
the Scrapping Disposal Process (The release
procedures inside vehicle are just regarded as those
about to be scrapped).
The special test and release tools are referred to in
T-96—Check of Special Tools Release Tool.
Park a vehicle on an open and large place. Avoid
strong wind and close all doors and windows.
Turn the ignition switch to the LOCK position.
Remove the negative cable of battery and wait for
more than 1min.
Release as per the suitable procedure, the
driver-sided safety airbag module, occupant-sided
safety airbag module, lateral safety airbag module or
pretensioning safety belt.
Driver-sided safety airbag module
1. Remove the steering column cover.
2. Disconnect the connector of clock spring.
3. As shown in Fig., connect the switch harness of
special tool with the clock spring.
4. Connect the special release tool with the switch
harness of special tool.
5. Connect the red clamp of special release tool
with battery positive terminal, and the black
clamp with battery negative terminal.
6. Confirm that the red light on the special release
tool is lit.
7. Be sure that all staff stay at least 5m {20ft}
away from the vehicle.
8. Press the trigger switch on the special release
tool to release the driver-sided safety airbag
module.
Occupant-sided safety airbag module
1. Remove the sundries bin.
2. Disconnect the connector of occupant-sided
safety airbag module.
3. As shown in Fig., connect the switch harness of
special tool with the occupant-sided safety
airbag module.
4. Connect the special release tool with the switch
harness of special tool.
Clock spring
connector
Trigger
switch
Modul
e connector
of
occupant-side safety
airbag