HAIMA 7 - Window Glass; Removal of Front Windshield; When the Windshield Is Not Reused Anymore; When the Windshield Is Reused

Window glass
S-35
Window glass
Removal of front windshield
1. Remove the interior rear-view mirror
(See——Rear-view mirrors, Removal of
Rear-view mirrors)
2. Remove the front wall grille (See——External
Accessories, Disassembly/Assembly of Front
Wall Grille)
3. Remove the roof (See——Roof,
Disassembly/Assembly of Roof)
4. Cover the protective tape on the border of
bodywork to prevent scratch.
5. Cover the protective tape on the dashboard to
prevent scratch.
Warning:
● Prior to use of a scraper, wear gloves,
otherwise it will result in injury.
Attention:
● The windshield molding is replaceable.
6. Cut off with a scraper, the flanges of
windshield molding.
When the windshield is not reused
anymore
1. Remove the pedestal (See——Rear-view
mirrors, Removal of Pedestal)
Attention:
● If it is difficult to remove the sealant of a
certain component, use a piano string as
shown in Fig., according to the steps as
indicated “When the Windshield is Reused”.
2. Use the tool as shown in Fig, and insert its
lame into the sealant;
3. Draw the tool along the edge of glass;
4. Remove the windshield.
When the windshield is reused
1. Pierce through the sealant with an awl from the
interior to exterior and drill a small hole
(except the fixer)
Warning:
● Wear gloves during use of piano string,
otherwise it will result in hand injury.
2. Pass the SST (piano string) through the small
hole. Bind both ends of piano string on the
handle.
Front windshield
molding
Fixer (windshield snaps + fastener)
Flange
Roof
panel
Front top
beam
Damping
strip
Section view A-A