HAIMA 7 - Setting of Driver-Side PW Motor; Check of the Response Function of Power Windows

Rear doors
S-15
Setting of driver-side PW motor
Attention:
l As the initial value of new regulator has been preset, it is unnecessary to reset.
l As the initial value of new PW motor has been preset, start from the 3
rd
step;
l In case of the following phenomena, the power door will be unable to return normally.
— PW glass not installed; use the power window motor.
— Replace the door glass;
— Window regulator groove replaced;
— PW regulator dismantled.
1. Remove the electric motor from the strut bar;
2. Connect the terminal G of motor with the battery and the terminal A with the grounding. Rotate
counterclockwise the motor output shaft at least 4 circles (at least 6 circles).
Connection
In practice
A G
GND B＋ Upward
3. Make the glass bracket lower than the position
of high-end cabinet between 65mm-95mm (the
glass can be fitted only within this range).
4. Fit the motor on the strut bar;
5. Install the PW regulator of front door;
6. Install the front door glass on the window
regulator.
7. Connect the master switch of power window.
8. Power on;
9. Place the switch in the ON position;
10. Close the power window by switch;
11. Repeat the 2
nd
step after the PW automatically
closed.
Check of the response function of power
windows
Attention
l After the PW motor restarted, the
auto-response cannot be done immediately,
repeat 10 to verify.
12. Check the auto-response function;
Upward Downward
Driver
-
side electric
motor
Element
-
side connector (viewed
from the terminal side)
Turn counterclockwise
Output shaft
Holder
Glass positioning hole (bolt
hole)
Bracket
Holder underlayer