Switch and relay
T-65
Switch and relay
Removal/installation of combination switch
1. Disconnect battery negative cable;
2. Remove the driver-sided safety airbag module
(See T—Removal/Installation of Driver-Sided
Safety Airbag Module);
3. Remove the steering wheel (See
N—Removal/Installation of Steering Wheel
and Steering Column);
4 Remove the steering column cover;
5 Remove the clock spring (See
T—Removal/Installation of Clock Spring);
6 Remove as per the order indicated in the Table;
7 The installation procedure is in reverse order
with that of removal.
1 Connector
2 Screw HQ99834-0510 (3.9～5.9 N.m)
3 Combination switch
Disassembly/assembly of combination
switch
1. Loosen R/L screws;
2. Remove separately the switches of wipers,
washers and lamps;
3. The assembly procedure is in reverse order of
that of disassembly;
1 Screw
2 Wiper and washer switches
3 Auto lamp switch
4 Combination switch
Removal/installation of auto lamp switch
1. Disconnect battery negative cable;
2. Remove the steering column cover;
3. Remove as per the order indicated in the Table;
4. The installation procedure is in reverse order
with that of the removal.
1 Connector
2 Screw
3 Auto lamp switch
Check of auto lamp switch
1. Remove auto lamp switch;
2. Check with an ohmmeter the continuity
between the terminals of auto lamp switch. If it
fails to meet the technique requirements,
replace the auto lamp switch.
Headlamp switch
Switch position
Terminal
Continuity
Bright
Dark
Flashing by
Off
Off
On Headlamp
High
To Next Page
Loading...