Switch and relay
T-69
Check of folding switch of rear-view
mirrors
1. Remove the folding switch of rear-view
mirrors;
2. Check, with a multimeter the continuity of
switch terminal according to the diagram. If it
fails to meet the technique requirements,
replace the switch.
Removal/installation of power window
switch
Removal/maintenance of main power
window switch
1. Remove battery negative cable;
2. Pry out the switch panel by use of a straight
screwdriver;
3. Disconnect the main switch connector of power
window;
4. Remove the mounting screw by use of a
screwdriver;
5. The installation procedure is in reverse order
with that of the removal.
1 Left front door assembly
2 Switch panel of power window
3 Main power window
4
Self-tapping screw HQ99874-0412 (torque:
not more than 2.9 N.m)
Check of main power window switch
1. Sometimes, there are cases such as the power
windows cannot move up/down or the main
switch of power window having the anti-trap
function cannot efficiently perform its function
when the main switch of power window is
normally operated.
2. Confirm that the harness led to the main switch
of power window is in sound connection, the
anti-trap stop switch and window regulator
operate in normal state, the auxiliary power
window switch in normal performance and the
lock switch not pressed down.
3. If the window regulator is still unable to work
properly, it means the main switch of power
window is damaged, please replace the main
switch of power window;
4. If the anti-trap function ineffective or unable to
properly close the windows, please check
whether there is pulse signal issued from the
window regulator of left front door. The check
method of pulse signal is shown as below:
1) Use an oscillograph;
2) Connect the signal terminal of oscillograph
with the PIN D as shown in Fig. below:
Connector at harness side
Diagram of folding switch of
rear-view mirrors
Terminal definition of folding switch
of rear-view mirrors
state
To Next Page
Loading...