Switch and relay
T-68
Installation/removal of level adjustment
switch (optional)
1. Disconnect the negative cable of battery;
2. Remove the side panel of dashboard;
3. Compress by hands the upper/lower snaps on
the switch behind the dashboard until the
switch is able to pass through the mounting
hole;
4. Take out the switch;
5. The installation procedure is in reverse order
with that of the removal.
1 Dashboard
2 Level adjustment switch
Check of level adjustment switch
1. Remove the switch of level adjustment;
2. Test by use of a multimeter, the continuity
between the rheostat terminals according to the
diagram. If it fails to meet the technique
requirements, Replace rheostat.
Installation/removal of folding switch of
rear-view mirrors (optional)
1. Disconnect battery negative cable;
2. Remove the side panel of dashboard;
3. Compress by hands the upper/lower snaps on
the switch behind the dashboard until the
switch is able to pass through the mounting
hole;
4. Take out the switch;
5. The installation procedure is in reverse order
with that of the removal.
1 Folding switch of rear-view mirrors
2 Dashboard
Circuit diagram
Snaps of upper/lower ends
Diagram
Snaps
To Next Page
Loading...