Front suspension
R-4
Front suspension
Removal/installation of front shock absorber and spring
Attention:
Carry out the following procedures prior to the removal of ABS wheel speed sensor. If the sensor pulled by
inadvertence, it may result in break-circuit of harness. before carrying out the following procedure, remove
the ABS wheel sensor corresponding to the axle, and fix it in a suitable position to prevent the wheel sensor
from inadvertent drawing during the maintenance process.
1. Remove in the order as shown in the Table；
2. Install in the reversing order of removal；
3. Check the alignment of front wheels. If non-conform to the specified provision, adjust the alignment of
front wheels (Refer to R——Alignment of Front Wheels)
1 Clips and braking hose
2 Locknut
3 Mounting bolt of shock absorber
4 Flange nut
5 Rubber mat
6 Damping column assembly
7 Piston rod nut
8 Upper support of shock absorber
9 Bearing
10 Upper spring seat
11 Upper rubber mat of helical spring
12
Helical spring.
See the Installation Instructions
13 Dust cover
14 Buffer block
15 Lower rubber mat of helical spring
16 Shock absorber
To Next Page
Loading...