Safety airbag system
T-53
connector of lateral safety airbag sensor or removal
of the lateral safety airbag sensor may enable the
lateral safety airbag sensor to work and induce the
module of lateral safety airbag to release, cause
serious personnel injury. Prior to disconnecting the
connector of lateral safety airbag sensor or remove
the lateral safety airbag sensor, turn the ignition
switch to the LOCK position, and then remove the
negative cable of battery, wait for more than 1min to
exhaust the energy of SAS unit stored in the standby
power supply.
If the lateral safety airbag sensor is under effect of
vibration or the sensor disassembled, the lateral
safety airbag module may suddenly perform release
and cause personnel injury or unable to properly
work and cause serious accident, thus keep the
lateral safety airbag sensor from vibration or do not
disassemble the sensor. As the lateral sensor is
inbuilt in the module of lateral safety airbag module,
After the lateral safety airbag module performed the
release, problems may be resulted in the module. In
case of an internal fault, even if there were no visual
damage or deformation, the safety airbag module
may be unable to properly work, and cause serious
personnel injury, if the lateral safety airbag sensor is
repeatedly used.
The lateral safety airbag sensor shall be replaced by
a new one. The lateral safety airbag sensor is unable
to make bench test and self-test on the pretensioning
safety belt.
The test of safety belt pretensioner by use of an
ohmmeter may make the pretensioning of safety belt
released and result in serious personnel injury,
hence, do not test the pretensioner of safety belt
with an ohmmeter, use the On Board
Diagnostics(OBD) instead to detect the fault of
pretensioning safety belt.
Operation of components
The components are contaminated by oil and grease
etc. which, in case of an accident, may cause the
safety airbag module and pretensioning safety belt
not to release and unfold, and result in serious
personnel injury, do not let the components
contaminated by oil and grease etc.,
The insertion by a screwdriver etc, into the
connector of safety airbag module or the
pretensioning safety belt may damage the connector
and cause the safety airbag module or pretensioning
safety belt to abnormally release, and result in
serious personnel injury, Therefore, do not insert
foreign matters into the connector.
Repeated use of components
Even if the safety airbag module or pretensioning
safety belt did not release during a collision, and
there were no damaged traces on the surface of
safety airbag module or pretensioning safety belt, its
interior would have been damaged and consequently
result in wrong operation. The operation errors may
cause serious personnel injury, the self-test shall be
made on the undamaged safety airbag module or
pretensioning safety belt to determine whether it can
be repeatedly used.
Removal/installation of pretensioning
safety belt
As for the removal and installation of pretensioning
safety belt, please refer to the Removal/Installation
of Front Row Seat Safety Belt.
Release procedures of safety airbag
module and pretensioning safety belt
Warning
The disposal of the safety airbag module and
pretensioning safety belt not yet released under
working state may cause accidental release of the
safety airbag module and pretensioning safety belt
and result in serious personnel injury. Do not reject
the safety airbag module and pretensioning safety
belt not yet released under working state.
If the special release tools and switch harness not
available, please consult the nearest Haima
automobile agent for help
To Next Page
Loading...