Floor covering
S-52
15. Install as per the reverse order with that of
removal.
Disassembly/assembly of trim panel of rear
door
1. Disconnect the negative cable of battery;
2. Remove the screw cap A;
3. Remove the screw B;
4. Remove the trim cover C.
5. Remove the trim cover of armrest D;
6. Remove the screws E (two pcs).
7. Remove the pad F.
8. Remove the screw G;
9. Remove the switch panel H;
10. Disconnect the connection of PW switch plug.
11. To loosen 10 snaps M, you need to insert your
hand into the slot of switch panel and pull
outward the door panel so as to disengage the
locking pin from the hole of sheet metal.
12. To dismount the door lamp, rotate
counterclockwise the bulb holder so as to
disengage it from the hole of door panel.
Pull
To Next Page
Loading...