Power supply system
T-2
Removal/installation of key-in reminder
switch
1. Remove the negative cable of battery;
2. Remove the steering column cover;
3. Remove the connector of key-in reminder
switch;
4. Remove the key-in reminder switch.
5. The installation procedure is in reverse order
with that of the removal.
Check of key-in reminder switch
1. Remove the negative cable of battery;
2. Remove the steering column cover.
3. Remove the connector of key-in reminder
switch;
4. Check, with an ohmmeter, the continuity
between the terminals of key-in reminder
switch. If it is non-conforming to the technique
requirements, replace key-in reminder switch.
Removal/installation of cigar-lighter
1. Remove the negative cable of battery;
2. Open the ashtray cover;
3. Remove as per the order indicated in the Table;
4. The installation procedure is in reverse order
with that of the removal.
1 Cigar-lighter plug
2 Socket
3 Anchoring disc of cigar-lighter
4 Plug (harness end)
Connection terminal
switch
Element side connector (viewed
from the terminal side)
Key-in reminder switch
Steering column lock
Terminal
Continuity
Key position
Inserted key
Non-inserted key
Element side connector (viewed from
the terminal side)
Start
Start
Lock
Lock
ACC
On
On
To Next Page
Loading...