Generator and Starter
22
Lubrication system of starter
Warning
l When removing and installing the starter on the CBU, if the negative cable of
battery is not loosened, the starter terminal B will produce sparks by the access
into connection or the contact with the body, this will cause personnel injury
and result in the electrical component damage, thus you should firstly remove
the negative cable of battery when doing the following operations.
1. Remove the negative cable of battery.
2. Disassemble as per the order shown in Fig.
3. Assemble in the reversing order of disassembly.
1 Cable terminal B
2 Cable terminal S
3 Starter
Check of starter
On-board check
1. Confirm that the battery has been charged.
2. Start up the starter to confirm it is running in stable operation and without noise.
l If incorrect, set the ignition switch onto the “START”position and measure the
voltage at the terminals S and B.
— If the voltage is out of the specified range, check and repair the harness and ignition
switch.
— If the voltage is in the specified range, remove the starter and check the solenoid switch
and starter.
Standard value: ＞8V
No-load test
1. Confirm that the battery has been charged.
2. As shown in Fig., connect the starter, battery,
voltmeter and ammeter.
3. Have the starter run and confirm it runs in the
stable operation.
4. While the starter is running, measure the voltage
and current.
l If incorrect, repair or replace.
Standard
Voltage (V) 11.5
Current (A)
＜80
Ignition
switch
Terminal S
Battery
Starter
To Next Page
Loading...