Wiper and washer
T-10
1
Windshield washer motor (2 pcs)
2
Gasket
Check of windshield washer motor
1. Disconnect battery negative cable;
2. Remove washer fluid reservoir;
3. Connect the positive voltage of battery with the
motor terminal B and the terminal A with the
grounding;
4. Verify the operation condition of windshield
washer motor. Replace the windshield washer
motor if it doesn’t work.
Removal of windshield washer nozzle
1. Remove the acoustic baffle of engine bonnet;
2. Remove the windshield washer hose from the
windshield washer nozzle;
3. Remove the windshield wiper nozzle under the
engine bonnet with a 10mm socket wrench.
Installation of windshield washer nozzle
1. Connect the windshield washer hose with the
windshield washer nozzle;
2. Press down the windshield washer nozzle into
the mounting hole;
3. Adjust the nozzle of windshield washer;
4. Install the acoustic baffle of engine bonnet.
Adjustment of windshield washer nozzle
Insert an needle or similar tool into the nozzle of
windshield washer and adjust the direction of nozzle
as per the method shown in the following Fig.
Side joint of part (viewed from
the connection terminal side)
Windshield wiper nozzle
wrench
To Next Page
Loading...