Technique parameters
8
Technical specification of service
Items Parameters
Thickness of prominent rivet(mm{in}) ≥0.3{0.012}
radical cycle run-out(mm{in}) ≤0.7{0.028}
Flywheel
Radial run-out (mm{in}) ≤0.13{0.0051}
Engine oil pump
Gap between inner rotor tooth tip to
outer rotor (mm{in})
Standard 0.06～0.18{0.0024～0.0070}
Max. 0.22{0.009}
Gap between outer rotor and pump
body (mm{in})
Standard 0.100～0.181{0.0040～0.0071}
Max. 0.22{0.009}
Backlash (mm{in})
Standard 0.040～0.095{0.0016～0.0038}
Max. 0.14{0.006}
Pressure spring length (mm{in}) Pressure: 82.6-90.4N
{8.43-9.22kgf, 18.56-20.31lbf}
35.15{1.3839}
Knock-in distance of front end oil seal (mm{in}) [from
engine oil pump body edge]
0～1.0{0～0.039}
Rear oil seal
Knock-in distance of rear oil seal (mm{in}) [from the edge of
crankshaft rear cap]
0～0.5{0～0.019}
Plastic tightening bolt length
Cylinder cover bolt (mm{in})
Standard 104.2～104.8{4.103～4.125}
Max. 105.5{4.154}
Main bearing cap bolt (mm{in})
Standard 67.7～68.3{2.665～2.689}
Max. 68.7{2.705}
Connecting rod cover bolt (mm{in})
Standard 46.7～47.3{1.838～1.862}
Max. 47.6{1.874}
Tightening torque
Installation location
Torque rating
Remark
N•m kgf•m ft•lbf
Generator
To Next Page
Loading...