HAIMA 7 - Rear Doors; Check of the Auxiliary Switch of Power Window; Disassembly;Assembly of Front PW Regulator

Rear doors
S-12
Rear doors
6. Disconnect the negative connection of battery;
7. Remove the trim panel of rear
door(See——Disassembly/Assembly of Rear
Door Trim Panel);
8. Remove the switch panel;
9. Remove the screws and PW auxiliary switch;
10. The installation is in the reverse order with the
removal.
Check of the auxiliary switch of power
window
1. Remove the mounting panel of switch;
2. Check, with an ohmmeter, the terminal
connection of auxiliary switch.
Disassembly/assembly of front PW
regulator
1. Disconnect the negative cable of battery
2. Remove the front door glass
3. Disconnect the regulator connector of rear PW;
4. Remove the nut and then dismount the front PW
regulator.
Tightening torque:
6.87-9.80N·M{70-100kgf·cm, 60.8-86.7in·lbf}
5. The installation is in the reverse order with the
removal.
Switch panel
Regulator switch
Continuity
Switch position
Window closing
OFF
Window opening
Terminal
PW auxiliary switch
ON
OFF
Nut